Borrego 4WD V6-3.8L (2009)
12. Cover the wire joints with heat shrink tubes and subject heat shrink tubes to heat. Tape the wires with electrical tape as required.
13. *Replace the noise condenser wiring harness side connector with new one supplied in the kit.
^ Connect 127 to 127
^ Terminate 128; then cut and seal exposed wire end
Install all the removed components in reverse order of removal. Road test the vehicle to ensure proper operation*
AFFECTED PRODUCTION RANGE:
Borrego (HM) production from 5/20/2008 through 10/8/2008.
WARRANTY INFORMATION