Borrego 4WD V6-3.8L (2009)
1st Crash Unlock
2nd Auto Door Lock ( Auto Door Unlock )
3rd Key Reminder Unlock
4th Central Door Lock/Unlock
3. If there is equal output command during output Priority order same Door lock/unlock, input is ignore. if there is contrast output command during
output Priority order same Door lock/unlock, input is ignore and present output immediately discontinue and executes output that is inputted after
100 ms(except CRASH UNLOCK, Without waiting TIME 100 ms immediately action enforcement)
4. If there is a signal which has priority over existing action, it will be stopped Immediately and the signal makes its own action.
5. When was new output condition after existing output completion, send output after wait 100 ms by standard existing output completion point of
time.(except CRASH UNLOCK, Without waiting TIME 100 ms immediately action enforcement)
Outside Mirror
Manual Control
1. Manual Control for O/S Mirror RH
A. At the ACC or RUN ON state, if the mirror select switch in the SW ASSY P/WDW MAIN is the RH state and the mirror direction switches
(UP, DOWN, LEFT, and RIGHT) are operated, then the mirror motor shall be driven to control the mirror to the desired direction. (Controlled
by ADM)
Memory Operation By Memory Switch
1. When IMS Memory Commend Message is forwarded to MEMORY1 or MEMORY2 from DDM, the location of present MIRROR is memorized.
The thing you don't do MIRROR memorization of at the time of MIRROR MANUAL SW movement.
2. Inhibiting and releasing of saving mode may be carried out when any of following conditions is satisfied:
A. If 5 seconds is elapsed after the memory switch is turned on
B. If the ignition 2 is turned off
C. When saving is completed
D. If "Ignition Sw Sts" of the CAN communication data sent by the IPM is not "Run"
E. If "Inhibit Sw Sts" of the CAN communication data sent by the CLU is not "P"
F. If "Vehicle Speed" of the CAN communication data sent by the CLU is over "3Km/h
3. If the battery is removed, the memory must be cleared.
Reminder Operation By Memory Switch
1. At the location where MEMORY is O/S MIRROR when IMS Memory Commend Message is forwarded to RETURN1 or RETURN2 from DDM,
RETURN.
2. If the position switch (POS1 or POS2) has not been memorized, then the reminding operation shall not be performed.
3. During reminding operation, if a position switch (POS1 or POS2) is pressed, and then the latest pressed switch shall govern the reminding
operation.
4. Prohibit Condition for the Reminding Operation
A. When the mirror manual switch is being operated.
If "Ignition Sw Sts" of the CAN communication data sent by the IPM is not "Run"
B. If "Inhibit Sw Sts" of the CAN communication data sent by the CLU is not "P"
C. If "Vehicle Speed" of the CAN communication data sent by the CLU is over "3Km/h
Auto Reverse Function
