Borrego 4WD V6-3.8L (2009)
Front wiper and washer functions are active when the ignition key is in RUN position.
Else, Front wiper Ctrl and Washer Motor Ctrl are sent with OFF value.
Front wiper activation
Description
Front wiper activation modes:
-
Off mode: no wiper;
-
Low speed: the front wiper runs continuously with low speed;
-
High speed: the front wiper runs continuously with high speed
-
Mist: the front wiper runs continuously with low speed until the Mist button is released, then, the wiper stops at the next park position
Description
Washer activation logic with inactive front wiper:
When the front wiper is not active and if the washer signal is active for more than 200 ms and less than 600 ms, the following sequence is started:
T2 second (0.3 second) after the washer is switched ON, the front wiper signal is switched ON with the current level speed
T3 second (700 ms) the front wiper signal is switched OFF
T2 = 0.3 s.
T3 : 0.7 s.
Washer activation logic with inactive front wiper:
When the front wiper is not active and if the washer signal is active for more than T1=0.6 seconds, the following sequence is started:
T2 second (0.3 second) after the washer is switched ON, the front wiper signal is switched ON with the current level speed
T3 second (2.7 - 3.3 seconds) after the washer is switched OFF, the front wiper signal is switched OFF
T2 = 0.3 s.
T3 : 2.7 - 3.3 s.
Description
Washer activation logic with active front wiper:
When the front wiper is active, the current speed of the front wiper is kept during 0.3 sec of the washer signal and after T3 seconds (wiper activation due
to washer) the front wiper returns to the wiping speed requested by the switch or the rain sensor. Depending on the mode of wiper that is active, the
wiping action linked to the washer has to be stopped or not.
Here are the following wiper modes and the actions:
