Borrego 4WD V6-3.8L (2009)
Suspension Strut / Shock Absorber: Overhaul
Disassembly and Reassembly
Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary.
2. Loosen the lock nut.
Tightening torque:
76 - 95N.m (7.6 - 9.5kgf.m, 55 - 69lb-ft)
3. Disassemble the components of front strut assembly in sequence.
4. Reassembly is the reverse of the disassembly.
Inspection
Inspection
1. Check the components for damage or deformation.
2. Compress and extend the piston rod and check that there is no abnormal resistance or unusual sound during operation.
3. When disposing the shock absorber, fully extend the piston rod and then drill a hole on the section to discharge gas from the cylinder.
CAUTION:
The gas coming out is harmless, but be careful of chips that may fly when drilling. Be sure to wear safety goggles or eye protection when
performing this task.
