Forte L4-2.0L (2010)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Campaign SA072 - ECM Update For MIL ON/DTC P0564
GROUP Engine
NUMBER 092
MODEL 2011MY Forte (TD) w/2.0L engine + A/T
DATE January 2011
SUBJECT: SERVICE ACTION: ECM UPGRADE - MIL ON WITH DTC P0564 (SA072)
This bulletin provides information related to the ECM software upgrade of some 2011MY Forte (TD) 2.0L 6AT vehicles produced from start of
production to December 29, 2010 which may experience a Malfunction Indicator Lamp illuminated with the ECM (Electronic Control Module)
system-related DTC P0564.
^ P0564 - Cruise Control Multi-Function Input A Circuit
To ensure maximum customer satisfaction, Kia is requesting the completion of this Service Action on all affected Forte vehicles. Please perform this
Service Action for all dealer in-stock units prior to retail sales.
For confirmation that the latest reflash has been performed to a vehicle you are working on, verify ROM ID using the tables in this TSB.
To correct this condition, the ECM should be reprogrammed using the GDS or G-Scan download as described in this bulletin.
*NOTICE
A Service Action is a repair program without customer notification that is performed during the warranty period. Any dealer request to perform this
repair outside the warranty period will require DPMS approval.
Repair status for a VIN is provided on WebDCS (Service > Warranty Coverage > Warranty Coverage Inquiry > Campaign Information). Not Completed
Recall/Service Action reports are available on WebDCS (Consumer Affairs > Not Completed Recall Recall VIN > Select Report).
The issue number is SA072.
*NOTICE
^ A fully charged battery is necessary before ECM upgrade can take place. It is recommended that the Midtronics GR8 1299 system be used in ECM
mode during charging. DO NOT connect any other battery charger to the vehicle during ECM upgrade.
^ All ECM upgrades must be done with the ignition key in the "ON" position with the blower motor in the "OFF" position during ECM upgrade.
^ Be careful not to disconnect any cables connected to the vehicle or GDS during the PCM upgrade procedure.
^ DO NOT start the engine during ECM upgrade.
^ DO NOT turn the ignition key "OFF" or interrupt the power supply during ECM upgrade.
^ When the ECM upgrade is completed, turn the ignition "OFF" and wait at least 10 seconds before starting the engine, according to instructions
