Forte L4-2.0L (2010)
Perform the ECM upgrade in accordance with normal tool ECM upgrade procedures.
MANUAL MODE ECM UPGRADE PASSWORDS:
* Do NOT perform Manual Mode ECM upgrade unless Auto Mode fails.
7. When the GDS tool reports that the ECM upgrade has been successfully completed, click OK, turn OFF the ignition key, and wait at least 10 seconds
before attempting to start the engine.
8. Check for Diagnostic Trouble Codes using the GDS and erase any DTCs stored in the Engine and Transaxle control modules. If a DTC C1261 is set,
perform the "ASP Calibration" with GDS.
ASP Calibration Procedure
1. Using the 16-pin DLC cable from the GDS while still hooked to the OBD-II connector, located under the driver's side area of the instrument panel.
2. Select the "System Option", and the "ASP Calibration"
