Forte L4-2.0L (2010)
5. After installing the Front Impact Sensor, confirm proper system operation:
A. Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
Components and Components Location
Components
Repair procedures
Removal
Side Pressure Sensor
CAUTION:
-
Removal of the airbag must be performed according to the precautions/procedures described previously.
-
Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector (s).
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front door trim.
3. Disconnect the side pressure sensor connector and remove the side pressure sensor after removing 2 rivets (A).
Side Impact Sensor
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the door scuff trim.
3. Remove the center pillar trim.
4. Disconnect the side impact sensor connector.
5. Loosen the side impact sensor mounting bolt and remove the side impact sensor.
