Forte L4-2.0L (2010)
[System selection screen]
Vehicle Selection_ Airbag_Weight Classification System_WCS RESET_ENTER
(then, Completed is displayed)
(5) Perform the accuracy check by using the GDS.
[System selection screen]
Vehicle Selection_Airbag_Weight Classification System_WCS RESET_ESC
(6) Confirm the measured weight is within the standard value. And then press "ESC".
specification: -2.0kg ~ 2.0kg (-4.4lb ~ 4.4lb)
(7) Place a 37kg (81.57lb) weight on the passenger front seat.
(8) Confirm that the result of accuracy check is within the standard value.
specification: 31kg ~ 43kg (68.34lb ~ 94.79lb)
NOTE:
-
When performing the accuracy check, use a solid metal weight and place it at the center of the seat. If the weight made from liquid is used
or the weight slides, the check result may not accurate, and could result in unwanted fail
-
When the measured weight deviates from the standard value, check again all the fastening bolts are tightened properly. And make sure
there is no interference. During the tightening, be careful not to deform the seat rail or seat structure. If the accuracy check is still not inside
the standard value, replace the seat leg assembly.
-
When WCS reset operation not finished normally, replace the seat leg assembly.
5. After installing the ODS, confirm proper system operation:
A. Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
B. Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require
suppression and the passenger airbag is enabled.
