Forte L4-2.0L (2010)
2. Pull down the front strut dust cover and bumper rubber (A) as shown in the photo.
NOTICE
Pulling the dust cover downward will allow access to bumper rubber contact surface.
3. Use a clean rag or compressed air to remove any dirt or foreign material from the surface area where the strut insulator pad will be attached.
CAUTION
Always wear safety eyewear when blowing out the dirt and foreign material.
4. Use a pair of scissors to make a cut across one side of the strut insulator pad as indicated by the arrow.
5. Remove the protective cover from the strut insulator pad as shown in the photo.
