Forte L4-2.0L (2010)
2. Depress the clutch pedal slowly until all air is expelled.
3. Hold the clutch pedal down until the bleeder is retightened.
4. Refill the clutch master cylinder with the specified fluid.
CAUTION:
The rapidly-repeated operation of the clutch pedal in B-C range may disrupt the release cylinder's position. During the bleeding operation, press
the clutch pedal to the floor after it returns to the "A" point.
[M6GF2]
Concentric slave cylinder air bleeding procedure
1. After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the plug.
2. Loosening the plug screw, press and release the clutch pedal about 10 times.
NOTE:
Hold the air bleeder body not to rotate with a spanner(A). The holding is needed when the plug loosened or tightened.
3. Tighten the plug during the clutch pedal pressed. Afterwards, raise the pedal with a hand.
Tightening torque :
25 - 29Nm (2.5 - 2.9Kgf.m, 18 - 21lb-ft)
4. After pressing the clutch pedal 3 times more, loosen the plug and retighten it with the pedal pressed. Raise it again, then.
5. Repeat the step 4 two or three times. (until there is no bubble in the fluid)
CAUTION:
1. Do not clamp the pipe of a concentric slave cylinder.
2. Be careful not to damage O-rings.
