Forte L4-2.0L (2010)
15. Install a new spring clip onto the end of the inner CV joint splines. The axle assembly is ready to be installed into the transaxle assembly.
16. Install the axle assembly with a quick push into the transaxle to seat the spring clip. Be careful not to damage the axle seal during installation of the
axle shaft.
17. Insert the outer CV joint into hub/bearing and ensure correct spline alignment.
18. Tighten the following retainers as specified:
^
Ball joint/shield bolts to 72~87 lbs. ft. (97~117 Nm).
^
Strut link retaining nut to 72~87 lbs. ft. (97~117 Nm).
^
Tie-rod end castle nut to 17~25 lbs. ft. (23~33 Nm) and install new cotter pin.
^
Axle nut to 144~202 lbs. ft. (195~273 Nm), stake nut when torque is complete.
19. Install the tire and wheel assembly and torque to 65~80 lbs.ft. (88~108 Nm).
20. Repeat this same procedure on the R/S axle assembly.
21. Check the fluid level in the transaxle, top-off any lost lubricant and road-test for proper operation.
WARRANTY CLAIM INFORMATION: