Optima L4-2.4L (2001)
1. Position glass carefully: Hold glass from both its inner and outer surfaces. While tilting it towards hinge side of door, place it on small bracket
on window regulator assembly.
2. Loosely install two glass mounting bolts on window regulator assembly.
3. Reconnect window operating switch.
4. Connect negative battery cable.
5. Turn "ON" ignition and move glass up and down to ensure proper function.
6. Make adjustments as necessary.
7. Turn "OFF" ignition.
8. Disconnect window operating switch.
9. Disconnect negative battery cable.
10. Tighten two glass mounting bolts on power window regulator assembly.
Tighten two bolts to 69 - 104 lb-in (8 - 12 N.m, 80 - 120 kg-cm)
2. Install run channel. Use soap and water for lubrication.
1. Install plastic door screen.
2. Fasten plastic door screen.
3. Pull out electrical harness connector from plastic door screen.
4. Pull out remote control rod for inside door handle from plastic door screen.
3. Install pull handle bracket with two mounting screws.
