Optima L4-2.4L (2001)
3.
Locate driver SAB wire harness on underside of cushion.
4.
Carefully inspect SAB wire harness at section indicated for damage or evidence of having been pinched or cut by seat adjustment mechanism.
(Open protective split wrap tubing and inspect individual wires.)
5.
A.
If no wire harness damage is found, position wire harness and secure it to cushion spring with wire-tie as shown.
B.
If wire harness has been pinched, but insulation on wires has not been cut or punctured, tape the wires at the pinch location then wire-tie
harness to cushion spring as in step 5A.
Reconnect trim flap. Install campaign completion label on left rear door in position indicated. NO FURTHER ACTION IS REQUIRED.
If wire harness has been cut or punctured, continue on to step 6.
6.
Remove head rest.
