Optima L4-2.4L (2001)
10.
With S-04/S-05 inserted in the harness connector retainer install the new tie wrap (loosely) on to the S-04 / S-05 wiring conduit and firmly insert
the harness retainer into the newly drilled hole below connector S-08/S-09.
Do not tighten the tie wrap at this point!
11.
Insure no kinks or bends to the S-05 / S-06 connector harness and tighten the tie wrap trim away the excess. Confirm that the harness retaining tab
for the SRS harness is installed completely to the seat bottom assembly.
12.
Reconnect Connector(s) S-08/S-09.
13.
Reconnect the negative battery cable.
14.
Re-install the seat frame assembly on the front body studs and torque the front two (2) nuts (24 - 36 Nm/17 - 26 lb-ft.). Tighten the rear seat frame
bolts to (35 - 55 Nm/25 - 40 lb-ft.). Re-install the front and rear seat frame trim pieces.
15.
Repeat this procedure on the passenger side seat bottom.
16.
Turn the ignition key to the on position and insure the SRS/Airbag Warning lamp is not illuminated after ten (10) seconds.
Reset the clock and radio presets.