Optima L4-2.4L (2001)
7.
Remove trim covers from seat mounting locations, loosen and remove 2 nuts and 2 bolts, moving seat fore and aft for access.
8.
Disconnect negative battery cable and wait 30 seconds. Tilt seat backwards then reach under, remove harness clips from seat cushion frame as
required then disconnect seatbelt buckle switch connectors (S-08 and I-15) and [if equipped] power seat connector (P-01).
9.
Remove SAB connector (S-05) from clip, and disconnect it from harness by pulling back locking sleeve.
Note:
The SAB wire harness may be wire-tied to the seat cushion spring. If so, cut the wire-tie.
10.
Carefully lift seat and remove from vehicle. Position on suitable work surface, and protect upholstery.
11.
Firmly pull lower end of seat back rear cover away from seat to release attaching clips, then move cover down and remove.
