Optima L4-2.4L (2001)
16.
Wrap upholstery around cross bar and seat back corners, then fasten upholstery with plastic tabs and with hog-rings. Use Snapon YA808
upholstery pliers or equivalent.
17.
Reinstall lumbar support handle and secure with screw.
18.
Reinstall seat back rear cover by first moving up then pushing lower half firmly towards seat back to snap attaching clips to seat back frame.
19.
Position SAB wire harness and secure it to seat cushion spring with wire-ties as shown. Make sure to leave sufficient slack to allow for seat back
adjustment without pulling or stretching harness.
