Optima L4-2.4L (2001)
20.
Reposition seat cushion trim flap over crossbar as shown and re-attach retaining clips.
21.
Lift seat into vehicle and position it over mounting locations. Take care to avoid damaging connectors as seat is being placed in vehicle.
22.
Tilt seat backwards, then reach under and connect seat belt buckle switches (S-08 and I-15), power seat (P-01) [if equipped] and SAB connectors
(S-05). Fasten SAB connector in retaining clip, then re-attach harness clips to seat bottom.
23.
Re-connect negative battery cable.
24.
Secure seat to floor by installing 2 nuts and 2 bolts, moving seat fore and aft for access. Torque nuts to 26 lb-ft and bolts to 40 lb-ft. Reinstall trim
covers over mounting locations.
25.
Reinstall head rest.
26.
Connect scan tool, check for air bag DTC's and clear drivers SAB related codes. (If any non-related DTC's are found, repair/correct as required.)
