Optima V6-2.7L (2003)
After completing the cavity wax application, continue to blow shop air through the nozzle for a short time to clear any material from the nozzle.
Use a shop towel to clean any excess wax that has been sprayed onto the exterior portion of the sub frame or is dripping from the drain holes.
CAUTION
12. Spray undercoating on the underside of the subframe near the four (4) 40 mm access holes and 8 mm drain holes. Do not spray the entire subframe
with undercoating.
13. Cover all four (4) of the 40mm access holes with the hole plugs listed in the parts information section and apply a small amount of undercoating
across the plugs.
14. Lower the vehicle, open the hood and install the SC075 completion label on the panel above the the master cylinder.
