Optima V6-2.7L VIN 4 (2007)
Starter Motor: Service and Repair
STATATER
REMOVAL
1. Disconnect the battery negative cable.
2. Disconnect the starter cable (A) from the B terminal (B) on the solenoid (C), then disconnect the connector (D) from the S terminal (E).
3. Remove the 2 bolts holding the starter, then remove the starter.
4. Installation is the reverse of removal.
5. Connect the battery negative cable to the battery.
DISASSEMBLY
1. Disconnect the M-terminal (A) on the magnet switch assembly (B).
2. After loosening the 3 screws (A), detach the magnet switch assembly (B).
3. Loosen the through bolts (A).
4. Remove the brush holder assembly (A), yoke (b) and armature (C).
5. Remove the and packing (B).