Optima V6-2.7L VIN 8 (2006)
-
Do not spill water or oil on the SRS unit,or the front impact sensor or the side impact sensors and keep them away from dust.
-
Store the SRS unit, the front impact sensor and the side impact sensors in a cool (less than 40 degrees C / 104 degrees F) and dry (less than 80%
relative humidity, no moisture) area.
WIRING PRECAUTIONS
SRS wiring can be identified by special yellow outer covering (except the SRS circuits under the front seats). Observe the instructions described in this
section.
-
Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring, replace the harness.
-
Be sure to install the harness wires so that they are not pinched, or interfere with other parts.
-
Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-metal contact. Poor grounding can cause
intermittent problems that are difficult to diagnose.
PRECAUTIONS FOR ELECTRICAL INSPECTIONS
-
When using electrical test equipment, insert the probe of the tester into the wire side of the connector.
Do not insert the probe of the tester into the terminal side of the connector, and do not tamper with the connector.
-
Use a u-shaped probe. Do not insert the probe forcibly.
-
Use specified service connectors for troubleshooting.
Using improper tools could cause an error in inspection due to poor metal contact.
