Optima V6-2.7L VIN 8 (2006)
Steering Shaft: Testing and Inspection
BALL JOINT AND STEERING LINKAGE SEALS, STEERING AND DRIVE SHAFT BOOTS
1. These components, which are permanently lubricated at the factory, do not require periodic lubrication. Damaged seals and boots should be
replaced to prevent leakage or contamination of the grease.
2. Inspect the dust cover and boots for proper sealing leakage and damage. Replace them if defective.
STEERING AND DRIVE SHAFT BOOTS
1. Aluminum wheels need special attention. If salt or chemicals have adhered to the wheels, they need to be rinsed off as soon as possible. After
cleaning the wheels, apply a coating of wax to prevent corrosion.
2. When cleaning the vehicle with steam, do not apply steam directly onto the aluminum wheels.
-
Clean the hub surface.
-
After finger tightening the wheel nuts, tighten them to specifications.
-
Do not use an impact wrench or push on the wrench with your foot to tighten the wheel nuts.
-
Do not apply oil to the threaded portions.
