Optima V6-2.7L VIN 8 (2006)
INSPECTION
1. Check the hub for cracks and splines for wear.
2. Check the snap ring for crack or damage.
3. Check the knuckle inner surface for scoring and cracks.
REASSEMBLY
1. Apply thin coat of multi-purpose grease to the knuckle and bearing contact surface.
2. Using the special tool, press-in the bearing to the knuckle.
NOTE:
1. Do not press the inner race of wheel bearing. That will cause damage Of the bearing assembly.
2. When installing bearing assembly, always use the new one.
3. Install the snap ring into the groove of knuckle.
4. Using the special tool, press-in the hub to the knuckle.
NOTE: Do not press the outer race of the wheel bearing. That will cause damage of the bearing assembly.
5. Tighten the hub to the knuckle to 200 Nm (2000 kg cm, 148 ft. lbs.) with the special tool.
