Optima V6-2.7L VIN 8 (2006)
NOTE:
1) Do not pull on the drive shaft; doing so will damage the D.O.J.; be sure to use the pry bar.
2) Do not insert the pry bar deeply enough to damage the oil seal.
CAUTION: Do not apply the vehicle weight to the wheel bearing while the drive shaft is disconnected. If the vehicle's weight must be applied
(because of vehicle movement or some other reason), use the special tool to hold the wheel bearing, as shown in the image.
9. After releasing the auto tensioner, remove the drive belt. (V6 ENG.)
10. Remove the alternator assembly (V6 ENG.)
11. Remove the two center bearing bracket mounting bolts. Insert the pry bar between the center bearing bracket and the cylinder block to disconnect
the bracket from the cylinder block.
12. Remove the inner shaft from the transaxle.
13. Using the special tool, remove the tone wheel.
INSPECTION
