Rio L4-1.5L (2001)
Hood Latch Release Cable: Service and Repair
Hood Release Cable
Removal
1. Remove hood release handle. Refer to "Hood Release Handle".
2. Remove nut holding hood release cable in place at LH side of instrument panel.
3. Feed hood release cable through bulkhead.
4. Release clips holding hood release cable in place along top portion of engine compartment.
5. Remove hood release cable from position along left top portion of engine compartment.
6. Remove end of hood release cable from hood release on front portion of engine compartment.
7. Repair or replace hood release cable as necessary.
Installation
1. Install hood release cable to hood release on front portion of engine compartment.
2. Route and clip hood release cable along pathway from hood release to bulkhead.
3. Feed hood release cable through bulkhead into interior of vehicle.
4. Install mounting nut to secure hood release cable to instrument panel.
5. Install hood release handle. Refer to "Hood Release Handle".
