Rio L4-1.5L (2001)
Lubricate the piston seal with the pink grease and install it in the caliper.
2. Lubricate the piston with brake fluid and partially install the piston. The dust boot groove must remain above the caliper bore.
3. Lubricate the dust boot with the pink grease then install it on the piston.
4. Press the piston into the caliper until it bottoms in the bore.
5. Install a new dust boot retaining ring.
6. Install the bleeder screw.
7. Install the caliper bushings and new bushing seals.
8. Lubricate the inside surface of the bushings with the pink grease contained in the overhaul kit. Do not allow the grease to enter the bushing bore.
