Rio L4-1.5L (2001)
Notice By making the above adjustment, the clearance between the push rod and piston (after installation of the brake master cylinder to the
power brake unit) will be as shown in the table below.
2. Install the master cylinder attaching washers and nuts. Tighten the master cylinder attaching nuts.
Tightening torque:
9.81 - 15.7 Nm (1.0 - 1.6 kg-m, 7 - 12 ft. lbs.)
Brake pipe
3. Tighten the brake pipe flare nut with the SST.
Tightening torque:
13 - 22 Nm (1.3 - 2.2 kg-m, 10 - 16 ft. lbs.)
4. Connect the low fluid level sensor wiring.
5. Bleed the brakes.
