Rio L4-1.5L (2001)
2. Loosen the rear shock absorber attaching bolt.
3. Remove the ABS sensor from the back plate.
4. Remove the ABS sensor wire from the attaching clip.
5. After removing the rear seat and rear side door-trim, remove the ABS sensor and connector.
Installation
1. Install the ABS sensor and connect.
2. Install the rear seat and rear side door trim.
3. Install the ABS sensor wire attaching trim.
4. Put the ABS sensor into the back plate and install the ABS sensor.
Tightening torque:
8 - 12 Nm (0.8 - 1.2 kg-m, 6 - 8 ft. lbs.)
5. Install the rear shock absorber attaching bolt.
Tightening torque:
78 - 98 Nm (8.0 - 10.0 kg-m, 58 - 72 ft. lbs.)
6. Connect the negative battery cable from the battery.
