Rio L4-1.5L (2001)
3. Install a new O-ring by using the Piston Seal Replacer and the Rack Piston Seal Sizer.
4. Place the Short Rack Seal Protector over the end of the rack to protect the bushing. Install the bushing on the rack.
5. Place the Rack Oil Seal Protector over the rack as shown. Install the rack, with the rack oil seal protector, into the steering gear housing. Remove
the rack oil seal protector.
6. Use the Pinion Bearing Replacer to install the lower pinion bearing.
7. If the valve housing, steering gear housing, or pinion and control valve assembly have been replaced, perform the valve housing adjustment
procedure outlined in this section. If none of these components have been replaced, install any shims that were removed.
8. Use the Seal Installation Set to install a new Teflon(R) pinion seals on the pinion and control valve assembly.
a. Install the first seal (the seal closest to the bearing) by sliding the Mandrel over the valve assembly to the first seal groove. Push the seal into
the groove by using the Pusher.
b. Size the seal by sliding the large end of Sizer over the seal.
c. Before installing the second seal, place one Spacer, on the valve assembly as shown. Install and size the seal by using the Mandrel and the
Pusher.
