Rio L4-1.6L (2004)
Verify that the distance from the floor panel to the center of the pedal pad is as specified when the pedal is depressed with a force of 490.33 N (50 kg)
MIN.
Pedal-to-floor clearance: 2.76 inch (70 mm)
If the distance is less than specified, check for the following problems:
1. Air in brake system
2. Malfunction of automatic adjuster (rear drum brakes)
3. Worn shoes or pads
INSTALLATION
1. If necessary, install the brake pedal stop bumper, foot pad, and bushings.
2. Position the brake pedal spacer and slide the pivot bolt through to hold it in position.
3. Position the return spring on the brake pedal.
4. Position the clutch pedal, if equipped, and slide the pivot bolt through to hold it in position.
5. Install the clutch pedal spacer, if equipped.
6. Install the pivot bolt attaching washers and nut.
7. Install the brake pedal clevis pin and split pin.
8. Connect the negative battery cable.
