Rio L4-1.6L (2004)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC P0101
VOLUME
3
GROUP
Engine
NUMBER
020
MODEL
Rio
DATE
January 2005
SUBJECT:
2004 RIO ECM UPGRADE
This bulletin provides information relating to a Rio ECM upgrade. Some 2004MY Rio vehicles built between 10/1/03 and 6/30/04 may experience a
Malfunction Indicator Lamp (MIL) condition with Diagnostic Trouble Code (DTC) P0101.
Use the procedure in this bulletin to reprogram the (ECM) software for 2004MY Rio vehicles with the DTC P0101 concern.
ROM ID INFORMATION TABLE:
Use the 32MB blue reprogramming card that was sent to your dealer in October 2004. Download the latest Hi-Scan Pro reprogramming software for the
32MB (blue label) reprogramming card from the Kia Service Information System (KSIS). The Downloads page is accessed by first logging onto KSIS,
then by clicking on the Downloads link located in the left-hand navigation frame. Dealers can also order a CD (optional) and ordering P/N 111220 BC.
BEFORE STARTING THE PROCEDURE:
Check the production date on the FMVSS door label to make sure that the vehicle is within the correct production range.
* NOTICE
^
Carefully charged battery is necessary before reprogramming can take place. DO NOT connect a battery charger to the vehicle during
reprogramming. Make sure the blower motor is OFF during programming.
^
All reprogramming must be done with the ignition key in the ON position.
^
Be careful not to disconnect any cables connected to the vehicle or Hi-Scan Pro during the reprogramming procedure.
^
DO NOT start the engine during reprogramming.
^
DO NOT turn the ignition key OFF or interrupt the power supply during reprogramming.
^
When the reprogramming is completed, turn the ignition key OFF and wait 20 seconds before starting the engine.
^
ONLY use approved reprogramming software designated for the correct model, year and engine size. Failure to do so may create other drivability
issues due to the use of the incorrect ECM/PCM calibration.
