Rio L4-1.6L (2004)
Notice: Be careful not to damage the parking brake cable.
15. Remove the torsion beam axle
16. Remove the rear shock absorber upper bolt.
17. Remove the spring upper seat bolt.
18. Use the SST or equivalent to press the bushing out of the torsion beam arms from the inboard side.
Inspection
Check the deformation,damage,or cracks, replace if necessary.
Installation
1. Position the bushing on the outboard sides of the torsion beam arms with the marks aligned parallel to the arm axis and press them in with the SST
or equivalent.
Notice: The arrow mark molded on the bushing face should be front side up.
The bushings may be lubricated with soapy water for easier installation. Do not use oil or grease
2. Install the spring upper seat.
Tightening torque: 27 - 40 ft. lbs. (36 - 54 Nm, 3.7 - 5.5 kg-m)
3. Install the rear shock absorber upper bolt.
Tightening torque: 27 - 40 ft. lbs. (36 - 54 Nm, 3.7 - 5.5 kg-m)
