Rio5 L4-1.6L (2006)
Sunroof / Moonroof Motor: Component Tests and General Diagnostics
SUNROOF MOTOR
INSPECTION
1. Disconnect the negative (-) battery terminal.
2. Apply the battery voltage to terminal 3, 6 and ground the terminal 1.
3. Ground the terminals as given table, and check that the sunroof unit operates as given table.
4. Make these input tests at the connector
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty; replace it.
RESETTING THE SUNROOF
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof
system as follows:
1. Turn the ignition key to the ON position.
2. According to the position of the sunroof, do as follows.
1. In case that the sunroof has closed completely or been tilted:
Press the TILT UP button until the sunroof has tilted upward completely.
2. In case that the sunroof has slide-opened:
Press and hold the CLOSE button for more than 5 seconds until the sunroof has closed completely. Press the TILT UP button until the sunroof
has tilted upward completely.
3. Release the TILT UP button.
4. Press and hold the TILT UP button once again until the sunroof has returned to the original position of TILT UP after it is raised a little higher