Rio5 L4-1.6L (2006)
12. Remove the parking brake cable (A) from the parking brake shoe (B).
INSTALLATION
1. Install the brake shoe (A) to the backing plate (B).
2. Install the shoe hold down pin (C) and the spring (D) by pushing the retainer spring (D) and turning the pins.
3. Check the parking brake cables for an identification paint mark and install as appropriate on the left and right sides appropriately.
Identification color
-Rear drum brake
Left side: Red
Right side: Yellow
-Rear disc brake
Left side: Green
Right side: White
4. After installing the strut (A) and upper return spring (B), install the adjuster assembly (C) and the lower return spring (D).
5. Apply a coating of the specified grease to each sliding parts of parking brake as shown.
