Rio5 L4-1.6L (2006)
1.
If necessary, remove and recover the A/C refrigerant with an appropriate R-134 recovery machine. Cover all compressor inlets/outlets and reduce
any compressor oil loss.
2.
Remove the compressor assembly from the vehicle.
3.
Using special service tool # 09977-29000, remove the disc & hub bolt. Refer to step 12 for bolt torque.
4.
Remove the spacer shim, located between the disc & hub and compressor shaft, if equipped.
NOTICE:
Do not displace the shim, this is a select fit item and will be reused during assembly.
5.
Remove the pulley assembly retainer snap ring.
6.
Remove the pulley assembly. Remove the field coil snap ring if equipped.