Rio5 L4-1.6L (2006)
12. PANIC ALARM (ETACS ONLY)
1. If TX Panic signal is received, Panic alarm shall be on for T1 by using horn, hazard. Panic delay time applied (When Panic switch is on for 0.5
sec, Panic alarm should on)
2. During Panic alarm, if (TX LOCK / UNLOCK / PANIC, KEY IN, DOOR KEY LOCK, DOOR KEY UNLOCK, T/GATE KEY UNLOCK,
TRUNK KEY UNLOCK) signals are received, Panic alarm shall be OFF.
3. During Panic operating, if the alarm condition is satisfied. Panic alarm shall be OFF.
4. The related matter to the Anti theft alarm function shall be as follows.
-
During the Anti theft alarm sequence, even if the TX Panic signal is received, the Anti theft alarm shall be maintained. (The Panic signal
shall be ignored.)
-
If the Anti theft alarm condition is satisfied during the Panic alarm sequence, the Anti theft alarm shall be output. (The Panic output shall
be OFF.)
-
If the Panic signal is received in the warning standby / warning / alarm completion / RELOCK standby modes, then the Anti theft function
shall be operated and the Panic alarm shall be ON.
5. During the Panic alarm sequence, although other registered TX signals are received, they shall be treated as the same TX signal.
