Rio5 L4-1.6L (2006)
Air Bag Control Module: Service and Repair
SRS CONTROL MODULE
REMOVAL
1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
4. Remove the floor console.
5. Press the lock (1), then pull back the connector lever (2) until it clicks.
6. Disconnect the SRSCM harness connector (A) and (B) from the SRSCM.
7. Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove the SRSCM.
INSTALLATION
1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Install the SRSCM with the SRSCM mounting bolts.
Tightening Torque (SRSCM Mounting Bolt) : 1.0 - 1.4 kgf.m (9.5 - 13.5 Nm, 7.0 - 10.0 lb.ft)
4. Connect the SRSCM harness connector.