Rio5 L4-1.6L (2006)
3. If the measured value exceeds the standard value, replace the tie rod assembly.
CAUTION: Even if the measured value is below the standard value, the tie rod that swings smoothly without excessive play may be used. If the
measured value is below 0.044 Nm (0.44 kg-cm, 0.03 ft. lbs.) replace the tie rod.
BELLOWS INSPECTION
1. Inspect the bellows for damage or deterioration.
2. Make sure the bellows are secured in the correct position.
3. If the bellows are defective, replace them with new ones.
DISASSEMBLY
1. Remove the tie rod end (B) from the tie rod (A).
2. After mounting the tie rod end (A) in a vise, remove the dust cover (B) from the ball joint.
3. Remove the bellows band (A).