Rio5 L4-1.6L (2006)
10. Remove both stabilizer brackets (A) and two bushes respectively
11. Remove the stabilizer bar.
CAUTION: Be careful not to do damage to pressure tubes.
INSPECTION
1. Check the stabilizer bar for deterioration and damage.
2. Check all bolts for damage and deformation.
3. Check the stabilizer link dust cover for cracks or damage.
INSTALLATION
1. Install the bushing (B) on the stabilizer bar (A).
NOTE: Bring clamp (C) of stabilizer bar (A) into contact with bushing (B).
2. Install the bracket on the bushing (B).
3. After tightening the bolts of the bushing bracket temporarily, install the bushing bracket on the opposite side.
Tightening torque: 45 - 55 Nm (4.5 - 5.5 kgf-m, 32 - 39 ft. lbs.)
4. Install the six subframe mounting bolts, then the two engine mounting bolts (A, B).
Tightening torque
Engine mounting: 50 - 65 Nm (5 - 6.5 kgf-m, 36 - 47 ft. lbs.)
Subframe mounting: 95 - 120 Nm (9.5 - 12 kgf-m, 68 - 86 ft. lbs.)
