Rio5 L4-1.6L (2006)
Wiper Motor: Testing and Inspection
Rear
INSPECTION
REAR WIPER / WASHER
1. Remove the 4P connector from the rear wiper motor.
2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3. Check that the motor operates normally. Replace the motor if it operates abnormally.
AUTOMATIC STOP OPERATION
1. Operate the motor at low speed using the stalk control.
2. Stop the motor operation anywhere except at the off position by disconnecting terminal
3. Connect terminals 2 and 3.
4. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal.
5. Check that the motor stops running at the off position.
