Rio Cinco L4-1.6L DOHC 16V (2003)
5. Seat the bearings by tightening the nut after raising the nut tap.
Tightening torque: 18 - 22 ft. lbs. (25 - 29 Nm, 2.5 - 2.9 kg-m)
6. Loosen the nut slightly until it can be turned by hand.
Before the bearing preload can be set, the amount of seal drag must be measured and added to the required preload.
7. Use a pull scale and measure the oil seal drag.
8. Pull the scale squarely. Take the oil seal drag value when the wheel hub starts to turn, and record it.
9. Add the oil seal drag value in the previous step to the specified value of 0.6 - 1.9 lbs. (2.6 - 8.5 N, 0.26 - 0.87 kg).
This is regarded as the standard bearing preload.
10. Turn the nut slowly to adjust to the standard bearing preload while checking with the pull scale.
11. Firmly fix the lock nut to the groove.
12. Install the hub cap.
13. Install the wheel and tire assembly.
Tightening torque: 65 - 87 ft. lbs. (88 - 118 Nm, 9.0 - 12.0 kg-m)
