Rio Cinco L4-1.6L DOHC 16V (2003)
4.
Remove the four (4) package shelf clips from the front edge.
5.
Remove the six (6) gray package shelf clips from the underside by pushing up from the bottom.
6.
Remove the right and left C-Pillar trim.
7.
Remove the right and left rear seat belt assemblies.
8.
Cut the right and left seat belt webbing so that the seat belts can't be reused and dispose of them properly.
9.
Install the new right and left rear seat belts making sure to insert the alignment tabs in the holes as shown. Torque the upper and lower anchor bolts
to 29-40 lb-ft.
*NOTICE:
Install the Lower Seat Belt Anchor With the Buckle Tongue Facing Forward, Without Twist in the Webbing.
