Rio Cinco L4-1.6L DOHC 16V (2003)
3. Install the ABS sensor to the attaching clip.
4. Install the ABS sensor to the knuckle assembly.
5. Connect the negative battery cable to the battery.
NOTE: A shield wire is used to prevent interruption of the input signal from the ABS sensor. Return the wire to its original position after repair.
Rear
REAR WHEEL SPEED SENSOR
ABS SENSOR (REAR)
REMOVAL
1. Disconnect the negative battery cable from the battery.
2. Loosen the rear shock absorber attaching bolt.
3. Remove the ABS sensor from the back plate.
4. Remove the ABS sensor wire from the attaching clip.
5. After removing the rear seat and rear side door-trim, remove the ABS sensor and connector.
INSTALLATION
1. Install the ABS sensor and connect.
2. Install the rear seat and rear side door trim
