Rio Cinco L4-1.6L DOHC 16V (2003)
3. Use the SST or equivalent, and compress the spring to unload the strut.
4. Remove the strut nut and lockwasher.
5. Remove the strut mounting block and plate.
6. Remove the bearing from the strut rod.
7. Remove the spring seat, seat rubber and spring.
8. Slide the bump stopper off the strut.
Caution: If replacing a spring, release the spring compressor progressively to prevent spring arching. Open the compressor jaws wide enough to
grip the new spring in the same position, and tighten the compressor screws progressively, compressing the spring until the strut can be assembled
without interference.
9. Before assembly, inspect the struts.
Inspection
Check the following points, repair or replace if necessary.
1. Oil leakage or abnormal noise from the MacPherson strut.
2. Deterioration or damage to the mounting block.
