Rondo L4-2.4L (2007)
13. Remove the evaporator core (A).
14. Install the heater core in the reverse order of removal.
15. Installation is the reverse order of removal, and note these items :
-
If you're installing a new evaporator, add refrigerant oil (ND-OIL8).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right
O-rings for R-134a to avoid leakage.
-
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle ; it may damage the paint ; if the refrigerant oil contacts the paint, wash it off immediately.
-
Apply sealant to the grommets.
-
Make sure that there is no air leakage.
-
Charge the system and test its performance.
-
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
-
Refill the cooling system with engine coolant.