Rondo L4-2.4L (2007)
Tire Pressure Module: Service and Repair
TPMS RECEIVER
REPLACEMENT
NOTE: When the receiver first arrives for replacement:
a. It will be in Virgin State.
b. It will not be configured for any specific platform.
c. It will not have any sensor ID's memorized.
CAUTION: It Is important to make sure that the correct receiver is used to replace the malfunctioning part i.e. Low line: 95800-3L500, High
Line: 95800-4D100 in order to have the correct inflation warning thresholds set.
1. Disconnect vehicle battery.
2. Remove malfunctioning part and replace new part.
NOTE:
^
Make sure the connector are plugged in properly.
3. Re-connect battery and turn Ignition on.
4. Check that TPMS lamp flash rate matches Virgin State indication.
5. Connect 'TPMS exciter' to the diagnostic connector.
