Rondo L4-2.4L (2007)
1. In IGN2 SW ON, if the MIST SW is ON for 60 ms or more, within 100 ms, and then, wiper output shall be ON for 700 ms within 100 ms.
2. If MIST SW input is continued, WIPER output shall be maintain the ON state, and then if MIST SW is OFF, the Wiper output shall be ON for
700 ms from OFF time.
4. REAR WASHER INTERLOCKING WIPER CONTROL
1. In state of IGN2 SWITCH ON, when REAR WASHER SWITCH is ON for more than T1 s (0.2 s), then after T2 s (0.3 s), WIPER output is
ON, and after WASHER SWITCH is OFF and WIPER output is ON for T3 (3 s, the time for operating WIPER 2-3 times), and then WIPER
output is OFF.
2. The operation of WASHER INTERLOCKING WIPER shall be prior to the INTERVAL WIPER function.
3. On start(in state of IGN1 SWITCH ON & IGN2 SWITCH OFF), ignore WASHER SWITCH input.
4. Ignore WASHER SWITCH input generated during WASHER WIPER operation, and after operating WASHER WIPER, adopt WASHER SW
input first.
5. The state of WASHER SW is decided by the voltage of BCM input end.
5. BUZZER SOUND
