Rondo L4-2.4L (2007)
Specification: Refer to SPECIFICATION.
3. Turn ignition switch OFF and disconnect the Scantool from the DLC.
4. Disconnect ETC module connector and measure resistance between ETC module terminals 1 and 2.
Specification: Refer to SPECIFICATION.
ETC MOTOR
1. Disconnect ETC module connector and measure resistance between ETC module terminals 3 and 6.
Specification: Refer to SPECIFICATION.
ETC SYSTEM INITIALIZATION
When ignition switch is turned from OFF to ON, ETC system learns the throttle angle in 1 sec..
1. Throttle valve moves from limp-home position to close position.
2. And then, it opens to about 15° and moves to limp home position