Rondo L4-2.4L (2007)
Oxygen Sensor: Testing and Inspection
HEATED OXYGEN SENSOR (HO2S)
INSPECTION
FUNCTION AND OPERATION PRINCIPLE
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed on upstream and downstream of the Manifold Catalyst Converter
(MCC). After it compares oxygen consistency of the atmosphere with the exhaust gas, it transfers the oxygen consistency of the exhaust gas to the ECM.
When A/F ratio is rich or lean, it generates approximately 1 V or 0 V respectively. In order that this sensor normally operates, the temperature of the
sensor tip is higher than 370 °C (698 °F). So it has a heater which is controlled by the ECM duty signal. When the exhaust gas temperature is lower
than the specified value, the heater warms the sensor tip.
SPECIFICATION
A/F Ratio.................................................................................................................................................................................................Output Voltage (V)
RICH............................................................................................................................................................................................................................0.6 - 1.0
LEAN...........................................................................................................................................................................................................................0.1 - 0.4
