Rondo L4-2.4L (2007)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
REPLACEMENT
NOTE
When the receiver first arrives for replacement:
1) It will be in Virgin State.
2) It will not be configured for any specific platform.
3) It will not have any sensor ID's memorized.
Caution
It is important to make sure that the correct receiver is used to replace the malfunctioning part i.e. Low line:
95800-3L500, High Line: 95800-4D100 in order to have the correct inflation warning thresholds set.
1. Disconnect vehicle battery.
2. Remove malfunctioning part and replace new part.
NOTE
1) Make sure the connector are plugged in properly.
3. Re-connect battery and turn Ignition on.
4. Check that TPMS lamp flash rate matches Virgin State indication.
5. Connect 'TPMS exciter' to the diagnostic connector.
