Rondo L4-2.4L (2007)
CAUTION:
^
Use a pry bar being careful not to damage the transaxle and joint.
^
Do not insert the pry bar too deep, as this may cause damage to the oil seal.
^
Do not pull the driveshaft by excessive force it may cause components inside the Joint kit to dislodge resulting in a torn boot or a
damaged bearing.
8. Pull out the driveshaft (A) from the transaxle case.
CAUTION:
^
Plug the hole of the transaxle case with the oil seal cap to prevent contamination.
^
Support the driveshaft properly.
^
Replace the retainer ring whenever the drive-shaft is removed from the transaxle case.
Installation
FRONT DRIVESHAFT ASSEMBLY
INSTALLATION